move the lifting handle by hand to adjust the height of the roller. when adjusting the double-stick roller coating machine, be sure to adjust the height of the two groups of rollers.
place the plate workpiece under the roller, then adjust the height of the roller, until the plate workpiece just touches the roller; take out the plate workpiece, and then rotate the lifting handwheel to descend 2-3 laps.
rotate and adjust the gap handle of the steel wheel until there is no gap between the steel wheel and the cots. then rotate the handle 2-3 turns to tighten the steel wheel and the rubber wheel.
turn on the oil pump switch and add the paint between the steel roller and the cots until the paint runs to the ends of the two rollers.
open the cots switch and then open the steel roll switch, in order to obtain a relatively flat fine coating, the speed of the steel roll is slower than the cots; open the transfer switch, the transfer speed and cots line speed to the same, so as to avoid the phenomenon of paint piling up the end.
back to home