first, the selection of special uv rolling coating, must clearly understand the configuration of special uv rolling coating equipment. because of the high requirements of equipment configuration can extend the service life of equipment, reduce the number of maintenance. in the early stage of research and development, our thinking mode also appeared some deviation, believing that as long as the roller is soft enough, it is good. we tried sponge wheel, pu wheel, plush roller, etc., but the results were not ideal. finally, we decided to try soft silica gel.
secondly, we are only targeted at the use and promotion, mainly for: plane milling; pool plate (middle plane part is high, all around low, high and low drop limit is 15mm at present). at present, we find that the biggest weaknesses of special-shaped parts are: right angle, dead angle, narrow groove (refers to width less than 3mm, depth greater than 3mm); hollow door, or stiffener (keel) too little. because of the various types of knives, there are a lot of soft rubber roller can not do, but as long as the customer with a change in the shape of the knife, most can roll coating.
uvfinally, the selection of special type of uv rolling coating equipment, to choose a guaranteed after - sale coating equipment manufacturers. after-sales service is guaranteed, which means that the flow of special-shape uv rolling coating process, any problems or questions, for the after-sales guaranteed coating equipment manufacturers, can be solved for you as soon as possible!
back to home